Denon RCD-M33 - Manual (Page 12)

ENGLISH
12
1
Manual tuning
NOTE:
• A humming sound may be heard when using a TV nearby while receiving AM programs. If
this happens, move the system as far from the TV as possible.
Example: Tuning in FM 92.50 MHz
(AM stations are tuned in using the same procedure.)
1 2 4 3
Press the power operation
switch to turn on the power.
2
Press the FUNCTION or
TUNER button to select TUNER
mode.
4 ✽
Use the Tuning +/– (TU+/ TU–) button to tune the
frequency to 92.50. Once the frequency is tuned in,
adjust the volume to the desired level using the VOLUME
control.
1
3
2
4
4
Main unit Remote control unit
Remote control unit
Main unit
Main unit
3
Press the 2 /BAND button on
the tuner to select the FM
AUTO.
Main unit Remote control unit
✽The function of the +/– button on the main unit may toggle between Tuning +/– and Preset +/–
functions.
• Pressing the – button while holding down the BAND button at the same time changes function
of the +/– button to Tuning +/–. (“TUNING” flashes for 5 seconds.)
• Pressing the + button while holding down the BAND button at the same time changes the
function of the +/– button to Preset +/–. (“PRESET” flashes for 5 seconds.)
• The +/– button is factory preset to function as a Tuning +/– button.
However, be sure that the +/- buttons function as the Tuning +/– button before proceeding with
step 4.
Auto Tuning
• When a program being broadcast in stereo is received, the “ST” indicator lights and the
program is received in stereo.
• If reception is poor and there is much noise in the stereo signals, press the BAND button to set
the FM MONO mode.
• When one of the Tuning +/– (TU+/ TU–) button is pressed, the frequency changes in steps of
200 kHz in the FM band, 10 kHz in the AM band.
• If one of the Tuning +/– (TU+/ TU–) button is held for over 1 second, the frequency continues to
change when the button is released (auto tuning) and stops when a station is tuned in. Tuning
will not stop at stations whose reception is poor.
• To stop the auto tuning function, press the Tuning +/– (TU+/ TU–) button once.
Remote control unit