Denon AVR-2112CI - Manual (Page 11)

7
ENGLISH DEUTSCH FRANÇAIS ITALIANO ESPAÑOL NEDERLANDS SVENSKA
Preparation
Playback
Setup Wizard
7
ENGLISH DEUTSCH FRANÇAIS ITALIANO ESPAÑOL NEDERLANDS SVENSKA
Playback (Basic operation)
Here, we explain how to perform simple operations.
For details, see the included CD-ROM (Owner’s manual).
Important information
Before starting playback, make the connections between the different
devices and the settings on the unit.
NOTE
Also refer to the operating instructions of the connected devices
when playing them.
Selecting the input source
Press the input source select button
( BD , SAT/CBL , TV , NET/USB , DVD ,
V.AUX , DOCK , TUNER , GAME1 ,
GAME2 or CD ) to be played back.
The desired input source can be selected
directly.
You can also use the following operation to select an input
source.
n Using the knob on the main unit
Turn SOURCE SELECT .
• Turning SOURCE SELECT switches the input source, as shown
below.
BD DVD TV
SAT/CBL GAME1 GAME2 V.AUX
CD NET/USB TUNER
DOCK
• When iPod 1 on the main unit is pressed, the input source
of this unit is switched to “DOCK” or “NET/USB” and the
connected iPod is automatically played (
vm page 26 “iPod
play function”).
n Using the “Source Select” menu
Switch the remote control unit to the J (MAIN ZONE) mode
when performing this operation ( vm page 105 “Operating AV
device”).
If the remote control unit is in
K (ZONE2) mode, the “Source
Select” menu will not be displayed when SOURCE SELECT is
pressed.
Player
BD
DVD
CD
DOCK
USB/iPod
Video
SAT/CBL
TV
GAME1
GAME2
V.AUX
Tuner
TUNER
Network
Favorites
Internet Radio
Media Server
Flickr
Pandora
Napster
Rhapsody
[ENTER] Enter [ ] Move
Source Select
The currently selected input
source is highlighted.
q Press SOURCE SELECT .
Display the “Source Select” menu.
w Use uio p to select the input source,
then press ENTER .
The input source is set and the source
selection menu is turned off.
• When using with an iPod connected directly to the USB port of this
unit, select “USB/iPod” for the input source.
• Input sources that are not going to be used can be set ahead of time.
Make this setting at “Source Delete” ( vm page 95).
• To turn off the source selection menu without selecting an input
source, press SOURCE SELECT again.
• When SOURCE SELECT is pressed, the AMP-operation mode starts
automatically ( vm page 105).
Selecting the input source