Denon AVR-2112CI User Manual

Page 10

ENGLISH

DEUTSCH

FRANÇAIS

ITALIANO

ESPAÑOL

NEDERLANDS

SVENSKA

Connect

Carefully check the left (L) and right (R) channels and

+ (red) and – (black) polarities on the speakers being

connected to the this unit, and be sure to interconnect

the channels and polarities correctly.

Connecting the speaker cables

Peel off about 0.03 ft/10 mm of sheathing from the tip of the
speaker cable, then either twist the core wire tightly or terminate it.

NOTE

• Connect so that the speaker cable core wires do not protrude

from the speaker terminal. The protection circuit may be
activated if the core wires touch the rear panel or if the + and –
sides touch each other (

m page 124 “Protection Circuit”).

• Never touch the speaker terminals while the power supply is

connected. Doing so could result in electric shock. (When the
Setup Wizard is running, follow the instructions in the Setup
Wizard screen for making connections.)

• Use speakers with the speaker impedances shown below.

Speaker terminals

Speaker impedance

FRONT

6 – 16 Ω

CENTER
SURROUND
SURR. BACK / AMP ASSIGN

n Connecting the speakers

The speakers are connected in “2. Speaker Connection” of the Setup Wizard but if you did not use or cancelled the Setup Wizard, connect the speakers as shown below.
For details, see the included CD-ROM (Owner’s manual).

7.1-channel

SBL

SBR

5.1-channel