Datavideo RMC-90 - Manual (Page 10)

9
T-bar is for performing effect transitions manually.
It can be either all the way up, all the way down, or
anywhere in between. To enable SE-800 T-Bar,
the T-Bar on RMC-90 need to be set at either end
of its travel.
PLEASE NOTE, T-Bar on RMC-90 CAN NOT
CONTROL AN AUDIO ONLY FADE EFFECT, it
controls only Video or Video with embedded
audio effect.
Press to turn on LED to
enable the GPI Trigger
input control on SE-800
Each press on this button will
playback the pre-stored function
key’s effect sequentially
Turn on LED to enable
the T-Bar effect control
for video
Turn on LED to enable the T-Bar
Audio effect control.
Note: Push down the T-Bar to
mute Audio
Press on the button to
Auto-Play the effect