D-Link DFE-530TX+ - Manual (Page 15)

DFE-530TX 10/100Mbps Ethernet Adapter for PCI Bus
Installation 7
another device. In such a case, the conflict of Interrupt
Number will cause faults in the behavior of both devices.
Then it is necessary to run the CMOS Setup utility, and
manually assign a non-conflicting Interrupt Number.
Connecting the WOL Cable
The WOL Cable is an interconnect cable with standard
3-pin connectors on each end. Please follow the procedures
listed below to ensure proper installation of the WOL cable.
1. Connect either end connector of the WOL Cable to the
NIC WOL Connector. Both ends of the WOL Cable are
identical, so either end may be used.
2. Examine the PC motherboard and/or refer to the manual
for the motherboard to locate the corresponding WOL
Connector on the motherboard. The actual location is
system dependent, but the motherboard may have a label
beside the WOL Connector. After you have located the
WOL connector on the motherboard, connect the cable.
3. Power-ON the PC and press or when
prompted to enter the PCI/ISA BIOS CMOS Setup.
Enable the WOL function or the power-ON function of the
PC. The name of this function is system dependent, but
may be located in a category heading titled something like
Power Management. Refer to your computer’s manual for
more information regarding the CMOS Setup Utility and
BIOS settings.
NOTE: If your system’s motherboard WOL Connector does not fit
the WOL Cable or does not have 3 pins, do not attempt to