Foxconn P9657AA-8EKRS2H User Manual
Page 41
Chapter 3 BIOS Description
34
v
Onboard FDC Controller
This option is used to set whether the Onboard FDC Controller is enabled.
The available setting values are: Disabled and Enabled.
v
Onboard Serial Port
This option is used to assign the I/O address and interrupt request (IRQ) for
the onboard serial port .
Note: Do not try to set the same values for serial ports 1 and 2.
v
UART Mode Select
Use this option to select the UART mode. Setting values include Normal,
IrDA, and ASKIR. The setting value is determined by the infrared module in-
stalled on the board.
v
UR2 Duplex Mode
This option is available when UART 2 mode is set to either ASKIR or IrDA. This
item enables you to determine the infrared function of the onboard infrared chip.
v
Onboard Parallel Port
This option allows you to determine onboard parallel port controller I/O ad-
dress and interrupt request (IRQ).
v
Parallel Port Mode
Select an address and corresponding interrupt for the onboard parallel port.
v
ECP Mode Use DMA
When the Parallel Port Mode is set to ECP or ECP+ EPP, this option is used to
select the channel for the ECP mode.
v
POWERON After PWR-Fail
This option is used to set what action the PC will take with the power
supply when it resumes after a sudden power failure.
SuperIO Device Menu
v
POWER ON Function
This option is used to set the power on method for your PC.
PDF 文件使用 "pdfFactory" 试用版本创建