Foxconn G9657MA-8EKRS2H User Manual
Page 43
Chapter 3 BIOS Description
36
v
Onboard FDC Controller
This option is used to set whether the Onboard FDC Controller is enabled.
The available setting values are: Disabled and Enabled.
v
Onboard Serial Port
This option is used to assign the I/O address and interrupt request (IRQ) for
the onboard serial port .
Note: Do not try to set the same values for serial ports 1 and 2.
v
Onboard IrDA Port
This option is used to assign the I/O address and interrupt request(IRQ) for
the IrDA port.
v
IrDA Duplex Mode
This option is used to set the IrDA duplex mode. The available setting values
are:Full and Half.
v
Onboard Parallel Port
This option allows you to determine onboard parallel port controller I/O ad-
dress and interrupt request (IRQ).
v
Parallel Port Mode
Select an address and corresponding interrupt for the onboard parallel port.
v
ECP Mode Use DMA
When the Parallel Port Mode is set to ECP or ECP+ EPP, this option is used to
select the channel for the ECP mode.
SuperIO Device Menu
PDF 文件使用 "pdfFactory" 试用版本创建