Foxconn G9657MA-8EKRS2H User Manual
Page 36
Chapter 3 BIOS Description
29
v
Boot Up Floppy Seek
This option controls whether the BIOS checks for a floppy drive while booting
up. If it cannot detect one (either due to improper configuration or physical
unavailability), it will appear an error message. The available setting values
are: Disabled and Enabled.
v
Boot Up NumLock Status
This item defines if the keyboard Num Lock key is active when your system is
started. The available setting values are: On and Off.
v
Gate A20 Option
This option is used to set up the A20 signal control necessary for access to
the 1MB memory.
v
Security Option
When it is set to “Setup”, a password is required to enter the CMOS Setup
screen; When it is set to”System”, a password is required not only to enter
CMOS Setup, but also to startup your PC.
v
APIC Mode
This option is used to enable or disable APIC function.
v
MPS Version Control For OS
This option is used to set up the version of MPS Table used in OS.
v
Delay For HDD(Seccs)
This option is used to set delay boot time of HDD controller.
v
Full Screen Logo Show
This item allows you to enable or disable the Full Screen Logo Show.
v
Small Logo (EPA) Show
This item allows you to enable or disable the EPA logo.
PDF 文件使用 "pdfFactory" 试用版本创建