Dixon RAM 48ZT BF - Manual (Page 33)

opeRatIon
33
Manual Transport
Bypass Linkages
When pushing or pulling the mower, engage the
ZT-2800 (Integrated Zero turn Transaxle) bypass
linkages. The ZT-2800 bypass linkages are located on
the rear of the frame, below the rear engine guard.
raise the deck into the highest cutting 1.
position.
Pull the bypass linkages up and out of the
2.
keyhole slots. release the levers with the
head outside the frame and held in the bypass
position.
To reengage the ZT-2800 to drive, reverse the
3.
above procedure.
load the machine into truck or trailer by driving up
ramps in low gear. do NoT lIfT! The machine is not
intended to be lifted by hand.
8058-032
Bypass linkage, ZT-2800 engaged
8058-032
Bypass linkage, ZT-2800 locked in the bypass position
WARNING!
Make no adjustments without:
the engine stopped, •
the ignition key removed, •
the parking brake activated •