Foxconn D42S 3.0 - Manual (Page 36)

29
3
SuperIO Configuration
► Serial Port1 Address
This item is used to assign the I/O address and interrupt request (IRQ) for the onboard serial
port 1.
► Serial Port2 Address
This item is used to assign the I/O address and interrupt request (IRQ) for the serial port 2.
► Parallel Port Address
This item is used to assign the I/O address for the onboard parallel port.
► Parallel Port Mode
This item is used to set parallel port mode.
► Parallel Port IRQ
This item is used to assign interrupt request (IRQ) for the onboard parallel port.
► OnBorard CIR Port
This item is used to assign the I/O address for onboard infrared chip.
CMOS Setup Utility - Copyright (C) 1985-2010, American Megatrends, Inc.
SuperIO Configuration
Configure ITE8721 Super IO Chipset Help Item
Serial Port1 Address [3F8/IRQ4] Allows BIOS to Select
Serial Port2 Address [2F8/IRQ3] Serial Port1 Base
Serial Port2 Mode [Normal] Addresses.
Parallel Port Address [378]
Parallel Port Mode [Normal]
Parallel Port IRQ [IRQ7]
OnBoard CIR Port [Disabled]
↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help
F9:Optimized Defaults
[3F8/IRQ4]