Dram timing configuration – Foxconn D42S 3.0 User Manual
Page 31
24
3
Memory Configuration
► DRAM Frequency
This item is used to set DRAM frequency. Setting values are: [Auto], [Max MHz].
DRAM Timing Configuration
► Configure DRAM Timing by SPD
This item is used to enable/disable provision of DRAM timing by SPD device. The Serial
Presence Detect (SPD) device is a small EEPROM chip, mounted on a DDR3 memory
module. It contains important information about the module's speed, size, addressing mode
and various other parameters, so that the motherboard memory controller (chipset) can better
CMOS Setup Utility - Copyright (C) 1985-2010, American Megatrends, Inc.
Memory Configuration
Memory Configuration
Help Item
DRAM Frequency
[Auto]
Auto
Max MHz
↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help
F9:Optimized Defaults
[Auto]
Options
CMOS Setup Utility - Copyright (C) 1985-2010, American Megatrends, Inc.
DRAM Timing Configuration
DRAM Timing Configuration
Help Item
Configure DRAM Timing by SPD [Enabled]
Disabled
Enabled
↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help
F9:Optimized Defaults
[Enabled]
Options