Foxconn D250S - Manual (Page 18)

11
2
front Panel Connector : fP1
This mother�oard includes one connector for connecting the
front panel switch and LE� Indicators.
Hard Disk leD Connector (HDD-leD)
Connect to the chassis front panel I�E indicator LE�. It
indicates the active status of the hard disks. This �-pin
connector is directional with +�- sign.
Reset Switch (ReSeT-SW)
Attach the connector to the Reset switch on the front
panel of the case; the system will restart when the switch
is pressed.
Power leD Connector (PWR-leD)
Connect to the power LE� indicator on the front panel of
the chassis. The Power LE� indicates the system’s status.
When the system is in operation (S0 status), the LE� is
on. When the system gets into sleep mode (S1) , the LE�
is blinking; When the system is in S3/S4 sleep state or
power off mode (S�), the LE� is off. This �-pin connector
is directional with +�- sign.
Power Switch Connector (PWR-SW)
Connect to the power �utton on the front panel of the
chassis. Push this switch allows the system to �e turned
on and off rather than using the power supply �utton.
Serial ATA Connectors : SATA_1/2
The Serial ATA connector is used to connect with SATA Hard
�isk or C� devices which supporting this feature. The current
Serial ATA II interface allows up to 300MB�s data transfer
rate.
EMPTY
H��-LE�
RESET-SW
NC
+
-
PWR-SW
+
-
PWR-LE�
1 �
10 9
FP1
SATA _1��
GN�
TX+
TX-
GN�
RX-
RX+
GN�
1