Foxconn D250S - Manual (Page 16)

9
2
2-2 Install other Internal Connectors
Power Connectors
This mother�oard uses an ATX power supply. In order not to damage any device, make sure all the
devices have �een installed properly �efore applying the power supply.
24-pin ATX power connector : PWR2
PWR� is the ATX power supply connector. Make sure that the power supply ca�le and pins are
properly aligned with the connector on the mother�oard. Firmly plug the power supply ca�le into the
connector and make sure it is secure.
4-pin ATX 12 V Power Connector : PWR1
Connect the 4-pin ATX 12V power supply to PWR1 and provides power to the CPU.
Pin # Definition Pin # Definition
1 3.3V 13 3.3V
� 3.3V 14 -1�V
3 GN� 1� GN�
4 +�V 16 PS_ON(Soft On�Off)
� GN� 1� GN�
6 +�V 18 GN�
� GN� 19 GN�
8 Power Good �0 NC
9 +�V SB(Stand �y +�V) �1 +�V
10 +1�V �� +�V
11 +1�V �3 +�V
1� 3.3V 24 GN�
PWR�
24 13
1� 1
We recommend you using a 24-pin power supply.
If you are using a �0-pin power supply, you need
to align the ATX power connector according to
the picture.
CA
UT
IO
N
!
�0-Pin Power
Pin No. 24
Pin # Definition
1 GN�
� GN�
3 +1�V
4 +1�V
3 1
GN� +1�V
4 2
PWR1