Foxconn A78AX-K - Manual (Page 45)

3
38
SuperIO Configuration
► OnBoard Floppy Controller
This item is used to enable/disable Floppy Controller.
► Serial Port1 Address
This item is used to assign the I/O address and interrupt request (IRQ) for the onboard serial
port 1.
► Serial Port2 Address
This item is used to assign the I/O address and interrupt request (IRQ) for the onboard serial
port 2.
► Serial Port2 Mode
This item is used to set the mode for the onboard serial port 2. The available settings are : The available settings are :
[Normal] : RS232 Mode.
[IrDA] : An IrDA device for maximum 115200 bit/s.
[ASK IR] : A faster IrDA for 1152000 bit/s.
► Serial Port2 Duplex Mode
When “Serial Port2 Mode“ is set to “IrDA“ or “ASK IR“, this item will appear. It is used to set the
transfer mode of the onboard serial port 2. The available settings are : [Half Duplex],
[Full Duplex].
► Parallel Port Address
This item is used to assign the I/O address for the onboard parallel (or Printer) port.
► Parallel Port Mode
This item is used to set the mode for the onboard parallel (or Printer) port.
► Parallel Port IRQ
This item is used to assign interrupt request (IRQ) for the onboard parallel (or Printer) port.
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
SuperIO Configuration
SuperIO Configuration SuperIO Configuration Help Item
OnBoard Floppy Controller [Enabled] Allows BIOS to Enable
Serial Port1 Address [3F8/IRQ4] or disable floppy
Serial Port2 Address Serial Port2 Address [2F8/IRQ3] controller.
Serial Port2 Mode [Normal] Serial Port2 Mode [Normal] Mode [Normal]
Parallel Port Address [378]
Parallel Port Mode [Normal]
Parallel Port IRQ [IRQ7]
↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit
F1:General Help F9:Optimized Defaults
[Enabled]