Replacing the aerosol fan filter – Formax ColorMaxLP Operator Manual User Manual
Page 60
60
Printer Maintenance
Formax
Replacing the Aerosol Fan Filter
As a general guideline, replace the aerosol fan filter every six months.
1. Turn off power to the printer. See
Printing Borderless (Full-Bleed) Labels
on page 32.
2.
Open the clamshell
to its highest position.
3. Insert the tip of a flat-blade screwdriver into the slot at the corner of the aerosol fan
assembly, and pry the cover off.
4. Remove the filter (
Figure 8
) and replace it with a new one.
5. Snap the cover back into place on the aerosol fan assembly.
6.
Close the clamshell
and top cover. Turn the printer back on.
Figure 8
Fan assembly
Tools
• Nitrile powder-free gloves
• Flat-headed screwdriver
filter
cover
aerosol fan assembly
slot