Formax FD 1200 - Manual (Page 11)

7
ADJUSTING FOLDS
To adjust the first fold loosen the two thumbscrews on the
upper fold plate. If the fold is too long slide the bar down to
decrease the fold length. If the fold is too short slide the bar
up to increase the fold length.
To adjust the second fold loosen the two thumbscrews on
the lower fold plate. If the fold is too long slide the bar up to
decrease the fold length. If the fold is too short slide the bar
down to increase the fold length.
Leading edge
Glue Line edge
2nd fold
1st fold
“Z” Fold
The fold plate stops may need to be adjusted up or down to fine tune the fold. Note: The 1st and 2nd folds are
different for “Z” and “C” folded forms, see the diagrams to determine the fold sequence.
1st fold adjustment, Upper fold plate
2nd fold adjustment, Lower fold plate
Leading edge
Glue Line edge
1st fold
2nd fold
“C” Fold