Fluke Biomedical 05-450 - Manual (Page 26)

05-450
Users Manual
18
Note
Since the coaxial cable supplies high voltage for detector operation,
splicing or re-terminating cables must be done very carefully.
Improper termination will result in shorting out the high voltage, a
DET FAIL condition and/or blown fuse condition.
Optional Remote Alarms
Remote alarm monitors such as the Model 05-446 may be operated by the
Product.
Maintenance
Warning
To prevent possible electrical shock, fire, or personal injury:
• Do not operate the Product with covers removed or the
case open. Hazardous voltage exposure is possible.
• Batteries contain hazardous chemicals that can cause
burns or explode. If exposure to chemicals occurs, clean
with water and get medical aid.
• Have an approved technician repair the Product.
• Use only specified replacement parts.
• Only certified technician or calibration personnel should
replace battery.
Cleaning Instructions and Precautions
The Product may be cleaned externally with a damp cloth using only water as the
wetting agent. Do not immerse the instrument in any liquid. Observe the following
precautions when cleaning:
1. Turn the instrument OFF and disconnect the instrument power cord.
2. Allow the instrument to sit for 1 minute before cleaning.
Replacement of Mains Fuse
Fuses should be changed by a maintenance technician approved by the
manufacturer only.
Warning
For continued protection against the risk of fire, replace only
with fuse of the specified type and current rating.
Detector Connector
Cables should be installed by qualified personnel only.
Warning
To prevent possible electrical shock, fire, or personal injury, do
not touch the center pin of the detector connectors unless the
unit has turned off and the power has been removed for at least
1 minute.