Fluke Biomedical VT Mobile Getting Started - Manual (Page 17)

Gas Flow Analyzer
Controls and Indicators
7
Table 4. Controls and Indicators
No. Name Description/Use
A Miniature RS-232 Serial Port Connect the RS-232 cable here (for use with VT for Windows
software.)
B Battery Eliminator Connector Connect the battery eliminator here. Use the battery eliminator
whenever possible.
C Battery Eliminator Indicator Glows green when the battery eliminator is supplying power to the
Analyzer. Note that this power source cannot recharge the battery.
D High Pressure Connector Connect the High Pressure Adapter here. The Analyzer makes high
pressure measurements from -2 to 100 psi.
E Flow and Low Pressure Connector Insert one of three coded modular connectors here; the Analyzer
automatically detects the connector type. The Analyzer use the
High-Flow Sensor to measure up to
± 150 lpm, the Low-Flow
Sensor to measure up to ± 25 lpm, or the Low-Pressure Adapter to
measure from -20 to 120 cmH2O.
F Display Screen Shows measurement parameters and statistics (Min, Avg, Max),
waveforms, and setup selections. English only.
G Oxygen Sensor Connector Connect the Oxygen Sensor here. The Analyzer makes O2
measurements from 0 to 100%.
H Temperature, RH Sensor Connector Connect the optional Temperature and Relative Humidity Sensor
here.