Fader start, English – Denon DN-X300 User Manual
Page 9
9
ENGLISH
5
FADER START
If the separately sold DN-S5000, DN-S3000, DN-S1000 and etc. players are connected to LINE1, 2, 3 or 4, they
can be started using the source input fader (Ch. Fader) or Crossfader, as long as the 3.5 mm stereo mini cords
have been connected.
R
L
R
L
R
L
R
L
F
ADER
FADER
FADER
FADER
PGM1
FADER
PGM1
FADER
PGM2
FADER
PGM2
LINE2
LINE
OUT
LINE
OUT
LINE4
F
ADER
DN-X300
(1)-2, 5
(1)-2, 5
(2)-2, 5
(1)-1
(2)-4
(1)-4
(1)-1
(1)-4
(2)-1
(2)-1
Channel Fader Start
Turn the CH 1/2 FADER START switches
#8.
1
2
Crossfader Start
NOTES:
• When the CROSSFADER REVERSE switch is set
to ON, the Crossfader's operating direction is
reversed.
• Channel Fader Start and Crossfader Start for the
same source will not operate simultaneously.
You must select from either one. If both CH
FADER START and CROSSFADER START A, B
switches are ON, priority will be the cross fader.
Move the Channel fader
@1 of
CH-1 or CH-2 control all the
way to the bottom.
3
Set the standby mode on CD player.
5
When you want to start the
player, move up the Channel
fader
@1 and the CD player
will begin playing.
1
2
Slide the Crossfader
@3 all the way in direction
opposite the source you want to start. (In the
following example, startup is done with the CD
player connected to PGM1.)
5
When the Crossfader
@3 is slid in the opposite
direction, CD player play will begin.
CD player (DN-S3000)
CD player (DN-S3000)
4
Use the CH 1/2 FADER
CONTOUR controls
$1 to
control the Channel fader
startup curve.
NOTE:
• When the CH 1/2 FADER REVERSE switch is set
to ON, the Channel fader's operating direction is
reversed.
Turn the CROSSFADER START A, B switches
#9.
3
Set the standby mode on CD player.
4
Use the CROSSFADER
CONTOUR control
$3 to
control the Crossfader
startup curve.