Flowserve DK 45 - Manual (Page 13)

Maintenance
– continued –
Torques
All torques are based at 0 °C room temperature.
. Observe danger note on page 4!
. Unscrew sealing plug
J and remove strainer H .
. Clean strainer, sealing plug and gasket seats.
4. Replace strainer and sealing plug in case of visible signs of wear or damage.
5. Replace gasket
I if damaged.
6. Apply heat-resistant lubricant to the thread of the sealing plug (use for instance WINIX ® 50).
7. Install sealing plug J with gasket I and strainer H . Tighten sealing plug with a torque
of 120 Nm.
Cleaning / replacing the strainer
Tools
■
Spanner A. F. 6 mm to DIN , form B
■
Spanner A. F. mm to DIN , form B
■
Spanner A. F. 0 mm to DIN , form B
■
Torque spanner 0 – 0 Nm, ISO 6789
WINIX ® 50 is a registered trademark of WINIX GmbH, Norderstedt
Item Designation Torque [Nm]
D
Regulator 0 90
A
Body screws 0 5
J
Sealing plug 0