Q-See QT17D324SC - Manual (Page 14)

QT19D328SC User’s Manual
14
Note: If time recording has been setup on this machine
，and power is connected during this period, then
the machine will start and enter into quad mode directly without needing to press
【on/off】button again to start
the machine.
If the channel numbers and time are not being displayed, please press
【ENTER】 button
on the remote control
unit or panel, and the channel numbers and time will be displayed on the screen.
NOTE: If the hard drive has not been installed before turning on the system
，or the hard drive is not
detected by the system after turning it on
，the monitor with hard drive will set off the alarm，Please log into
the system to turn off the alarm.
3.2.2 System Login
Note: Pre-delivery code for this system is
：000，the default password for administrator is 88888888，and it is
00000000 for user. Administrator has all operating rights. In order to insure secure running of the system,
administrators should change its code and default password of the machine as soon as possible.
When the host machine is started
，user can only operate the system when logged in (if the
password is effective). If there is no activity within 100 seconds after logging in, the system will enter into lock
up state
！
When the machine is just started or under lock up state, press the
【Login/Lock】Button on
Remote Control
Unit
，the login interface will appear on the screen, type in the code of the system（Pre-delivery setup：“000”），and then
type in the password
（password for administrator or user of this machine）.
⑴ If correct user’s password is typed in，the monitor will show “Password Correct” message on the screen，and
then after [Return] for confirmation
，users can operate each of the items within the permitted fields (the default
password for user is
：00000000).
⑵ If correct administrator’s password is typed in，the monitor will show “Password Correct” message on the
screen
，and then after [Return] for confirmation，administrator can do all of the operations on the system（The
default password for administrator is
：88888888).
3.2.3 System On and Off
When the system is monitoring video, please press the
【on/off】button in the remote control unit twice if you