Flowserve Valtek StarPac 1 Intelligent Control Systems - Manual (Page 23)

41-23 Flowserve Corporation, Valtek Control Products, Tel. USA 801 489 8611
Kit 17 - Pressure Sensor Adaptor Kit
Part No. 10203061
Description Quantity
PTFE cap for flush-mount sensors 1
Kit 18 - Pressure Sensor Adaptor Kit
Part No. 10070892
Description Quantity
Pressure sensor length adapters
w/Viton O-rings
1
Item Description
1. Electrical connection cable
2. Tubing, 0.035 wall thickness (see Table XII)
3. Swagelock nut
4. Swagelock ferrule set
5. Sensor nut
6. Environmental O-ring
7. Division II sensor fitting
8. Environmental O-ring
9. Pressure sensor
10. O-ring seal
11. Length adapter fitting
12. O-ring seal
13. Division I sensor fitting
14. Explosion-proof union
15. Wire crimp terminals
16. Four-pin connector
Figure 17: Body-mount Sensor Configurations
1
2
3
4
5
6
8
9
10
11
12
13
14
5
6
7
8
Boss on
valve body
15
16
NOTE: In July of 1993, the sensor manufacturer
shortened the process end of the pressure sensors. If
the StarPac uses the longer style sensors, order one of
the above adapter kits with the new sensor purchase.
Each kit will service two pressure sensors.
Kit 19 - Pressure Sensor Adaptor Kit
Part No. 10070893
Description Quantity
Pressure sensor length adapters
w/spiral-wound gaskets
1