Flowserve 2000 Series Digital Positioner - Manual (Page 22)

42-22
Flowserve Corporation, Valtek Control Products, Tel. USA 801 489 8611
Table XI: Flush Mount Pressure Sensor
Diaphragm
Material
Hastelloy C
Pressure sensor, 0-25 PSIA, flush 10103511
Pressure sensor, 0-50 PSIA, flush 10103512
Pressure sensor, 0-100 PSIA, flush 10103514
Pressure sensor, 0-150 PSIA, flush 10103516
Pressure sensor, 0-300 PSIA, flush 10103519
Pressure sensor, 0-500 PSIA, flush 10103521
Pressure sensor, 0-1000 PSIA, flush 10103522
NOTE: Flush mount sensors are not rated for Divi-
sion I applications.
Table X: Pressure Sensor Accessories
Description Number
PTFE cap for flush-mount sensors 10203061
Pressure sensor length adapters
w/Viton O-rings,
10070892
Pressure sensor length adapters
w/spiral-wound gaskets
10070893
This table is a combination of Kit 17 and Table XI.
1. Electrical connection cable
2. Tubing, 0.035 wall thickness (see Table XIII)
3. Swagelock nut
4. Swagelock ferrule set
5. Sensor nut
6. Environmental O-ring
7. Division II sensor fitting
8. Environmental O-ring
9. Pressure sensor
10. O-ring seal
11. Length adapter fitting
12. O-ring seal
13. Division I sensor fitting
14. Explosion-proof union
15. Wire crimp terminals
16. Four-pin connector
Figure 17: Body-mount Sensor Configurations
1
2
3
4
5
6
8
9
10
11
12
13
14
5
6
7
8
Boss on
valve body
15
16
NOTE: On July 1993, the sensor manufacturer
shortened the process end of the pressure sensors.
If the StarPac uses the longer style sensors, order
one of the above adapter kits with the new sensor
purchase. Each kit will service two pressure sensors.
Description