DeLonghi EAM3500 - Manual (Page 17)

17
16.1 Setting the clock
To set the clock, proceed as follows:
• Press the button (the light over the button comes on) then press the button repeatedly until
the appliance displays:
CLOCK 00:00
• Press the button to set the clock. (If you hold the button down, the time is changed
rapidly).
• Press the button to confirm the value;
• Press the button to exit programming mode or to change other parameters.
16.2 Setting auto-start time
This programs the time the appliance will come on automatically and be ready for use.
• Make sure the clock on the appliance is set as described above.
• Press the button then press the button repeatedly until the appliance displays:
NOTE 2: If it is hard to insert the infuser, before inserting it, squeeze to size by pressing it vigorously from
above and below at the same time, as shown in Figure 31.
NOTE 3: If it is still hard to insert the infuser, leave it out of the appliance, close the service door, unplug from
the outlet, then plug in again. Wait for all the lights to go off after the self-diagnosis, then open the door and
replace the infuser.
15.3 Cleaning the milk container
Proceed as follows:
• Wash the container and lid in a dishwasher or in hot soapy water.
• Make sure there are no milk residues inside the
two holes in the lid of the milk container indicated
by the arrows in the figure or the milk intake tube.
• To replace the components of the lid with the wor-
ding "STEAMED MILK - LATTE", insert the milk
spout and milk intake tube (the softer one) in the
hole in the lid as shown in fig. 20.
• To replace the components of the lid with the wor-
ding "FROTHED MILK - CAPPUCCINO", insert the
milk spout and milk intake tube (the harder one) in
the hole in the lid as shown in fig. 20.
Note: To avoid using the wrong intake tube, the “STEAMED MILK –LATTE” tube cannot be inserted in the
“FROTHED MILK – CAPPUCCINO” lid and the “FROTHED MILK – CAPPUCCINO” tube cannot be used in the
“STEAMED MILK – LATTE” lid.
16 CHANGING AND SETTING THE MENU PARAMETERS
After pressing the button, when the appliance is ready, you can use the internal menu to modify the fol-
lowing parameters and functions:
• Clock
• Auto-start time.
• Descaling process
• Coffee temperature • Length of time the appliance remains on
• Water hardness
• Factory default values
• Washing process