beautypg.com

Ready pre-ground, Hot water – DeLonghi EAM3500 User Manual

Page 13

background image

13

9 PREPARING ESPRESSO/COFFEE WITH PRE-GROUND COFFEE (INSTEAD OF BEANS)

• Press the button (fig. 16) to select the ground coffee function. This disables the coffee mill function.

The appliance displays:

READY PRE-GROUND

• Lift the lid in the center, place one measuring scoop of ground coffee in

the funnel (see fig. 17) and proceed as described in section 5.
Note: you can make just one coffee at a time by pressing the ,
or button once only.

• After using the appliance with pre-ground coffee, to go back to making coffee using beans, deactivate

the ground coffee function by repressing the button to prepare the grinder for operation again.

NOTE 1:

Never add the ground coffee when the appliance is off to avoid it from being dispersed inside the

appliance.

NOTE 2:

Never add more than one level measuring scoop, otherwise either the

appliance will not make the coffee, the ground coffee will be lost inside the applian-
ce, dirtying it, or the coffee will run off in drips and the message "GROUND TOO FINE
ADJUST GRINDER AND TURN STEAM KNOB" will be displayed.

NOTE 3:

When dosing the quantity of coffee to be added, use the measuring scoop supplied only.

NOTE E:

Do not use freeze-dried coffee or other materials that could damage the appliance

NOTE

: If the funnel blocks due to moisture inside the appliance or if more than one measuring scoop of pre-

ground coffee has been used, use a knife to push the coffee down (Fig. 18), then remove and clean the infu-
ser and appliance as described in paragraph 15.2 "Cleaning the infuser".

10 PRODUCING HOT WATER

• Always make sure the appliance is ready.
• Make sure the water spout is attached to the nozzle (fig. 4);
• Position a container under the spout (fig. 3).
• Press the button (fig. 1).
The appliance displays:

HOT WATER

and hot water is delivered from the water spout into the container below (you should not run off hot water
for more than two minutes at a time). To stop the flow, press the button. Once the set quantity of hot
water has been reached, delivery stops automatically.