Flowserve HV 215 - Manual (Page 29)

29
Attaching operating plates HV 215
Installation
– continued –
Attach the operating plates at both sides of the tank car near the valves so that they are clearly visible.
. Make sure that the surface onto which you want to stick the adhesive label is clean, dry and free of grease.
2. Remove the protective paper (“Controltac” printed on it) from the adhesive label.
3. Attach the operating plate at the desired position but do not yet stick it firmly to it.
As long as the operating plate is not firmly pressed against die surface you can still change its position.
4. To fix the operating plate permanently use a plastic spatula to press the adhesive label firmly against the surface.
Start in the middle of the label and make sure that no air gets trapped in.
5. Carefully strip off the protective sheet and, if necessary, press the corners of the operating plate again firmly
against the surface.
6. If there are air blisters prick a needle into them and then press the lable again firmly against the surface.
Attaching list indicating fluids
The fluid list must only be attached if bottom valves are used with a valve plug joint CR at both operating devices.
See drawing on page 4
Attach the fluid plates
Z at the middle of the inside of both flaps of the operating devices E so that they are
clearly visible.
GESTRA