Flowserve Gearex Rotary Gear Pumps External and Internal Bearing - Manual (Page 8)

EXTERNAL GEAREX USER INSTRUCTIONS ENGLISH 71569246 (2167B-E1)
Page 8 of 36
®
1.6.4.7 Maintenance to avoid the hazard
CORRECT MAINTENANCE IS REQUIRED TO
AVOID POTENTIAL HAZARDS WHICH GIVE A RISK
OF EXPLOSION
The responsibility for compliance with
maintenance instructions is with the plant
operator.
To avoid potential explosion hazards during
maintenance, the tools, cleaning and painting
materials used must not give rise to sparking or
adversely affect the ambient conditions. Where there
is a risk from such tools or materials, maintenance
must be conducted in a safe area.
It is recommended that a maintenance plan and
schedule is adopted.(See section 6 MAINTENANCE.)
1.7 Nameplate and warning labels
1.7.1 Nameplate
For details of nameplate, see the Declaration of Conformity.
1.7.2 Warning labels
WARNING
MECHANICAL SEAL FITTED
DO NOT ADJUST PUMP CLEARANCE WITHOUT
REFERENCE TO MANUFACTURER'S INSTRUCTION
MANUAL
WARNING
BEFORE STARTING THE PUMP ON SERVICE, CHECK
TO ENSURE CORRECT ROTATION OF MOTOR.
FAILURE TO DO THIS COULD RESULT IN SERIOUS
DAMAGE TO THE EQUIPMENT.
MECHANICAL SEAL WARNING ROTATION WARNING
P/N 2113931-001 P/N 2113932-001
WARNING
BEFORE GROUTING, REALIGN THIS UNIT
RECHECK ALIGNMENT BEFORE STARING,
FAILURE TO DO THIS COULD RESULT IN
SERIOUS DAMAGE TO THE EQUIPMENT.
REFER TO INSTALLATION MANUAL AND, OR
COUPLING INSTRUCTIONS FOR METHOD OF
CHECKING ALIGNMENT.
WARNING
THESE EYEBOLTS
ARE TO BE USED FOR LIFTING BEARING
CARTRIDGE AND SHAFT ONLY.
DO NOT USE FOR LIFTING ENTIRE UNIT.
GROUT WARNING LIFTING WARNING
P/N 2113934-001 P/N 9901701-001
LUBRICATION WARNING – QF-440-R01 (2124841)
Oil lubricated units only