1 casing, seal plate, diffuser and impeller, 2 motor shaft and stub sleeve (if fitted), 3 gaskets and o-rings – Flowserve PVML User Manual
Page 22: 4 motor bearings, 9 assembly, Fitting the neck bus, Fitting the impeller wearing rings, Fitting the case wearing rings
See also other documents in the category Flowserve Pumps:
- CESM-4 (28 pages)
- CESM-1 (32 pages)
- ATEX N (20 pages)
- CESM-2 (32 pages)
- WDX (46 pages)
- WX Worthington (52 pages)
- WMA2 (35 pages)
- WX Worthington (51 pages)
- Type RX (56 pages)
- LCH (40 pages)
- NM (48 pages)
- MJ Slurry (42 pages)
- Mark 3 (48 pages)
- MN (49 pages)
- MF (50 pages)
- CPXVC (32 pages)
- M Slurry (60 pages)
- PolyChem GRP (52 pages)
- CPXV fitted with FRBH hydraulics (44 pages)
- Durco Mark 3 ISO Frame Mounted (52 pages)
- MP1 Sier-Bath (48 pages)
- Twin Screw Rotary (56 pages)
- LNNC (56 pages)
- IDP CPXRV (48 pages)
- HWX Worthington (40 pages)
- U-MAG INNOMAG (40 pages)
- N-Series Worthington (20 pages)
- TB-MAG INNOMAG (44 pages)
- HDX IDP (64 pages)
- QLQC Vertical Worthington (61 pages)
- LPNV Worthington (48 pages)
- Mark 3 ISO Durco (32 pages)
- FP (40 pages)
- FM (36 pages)
- MEN-TI (36 pages)
- MEN (36 pages)
- FP (40 pages)
- MENBLOC 60Hz (36 pages)
- ME (36 pages)
- PVXM (31 pages)
- VTP (76 pages)
- PLEUGER (40 pages)
- APKD (55 pages)
- WJE IDP (28 pages)