Delta 36-902 - Manual (Page 13)

13
3. When ripping thin stock, it is sometimes more
convenient to use the fence in the horizontal position, as
shown in Fig. 42.
4. To move the fence along the guide rail, lift up clamp
lever (A), as shown in Fig. 43, slide fence to desired
position on the rail, and push down on clamp lever (A) to
lock fence in place.
5. The distance the fence is positioned away from the
blade is indicated by the two witness lines (B) and (C) Fig.
44, located on the cursor (D). Witness line (B) indicates
the distance the fence is away from the blade when the
fence is in the horizontal position, and witness line (C)
indicates the distance the fence is away from the blade
when the fence is in the vertical position. If it is necessary
to adjust cursor (D), make a test cut with the fence in
either the vertical or horizontal position, measure the
distance of the finished cut and move the cursor (D) by
loosening the two screws (E) Fig. 44. After adjustment is
completed tighten the two screws (E).
6. To remove the fence and fence body assembly (F)
Fig. 45, from the guide rail, lift up on fence clamping lever
(A) and turn lever (A) counterclockwise to the left indent
position. The fence assembly (F) can then be pulled
straight off the guide rail and removed.
Fig. 42
Fig. 43
Fig. 44
Fig. 45
A
B D C
E
F
A