Fire Magic 3050 Infrared Burnet Kit - Manual (Page 4)

REV 6 - 1502230915 L-C2-251 4
2. Pull out and completely remove the drip tray from the grill.
3. Remove the control panel. If needed, refer to the owner's manual
included with your grill.
4. Disconnect the existing electrode wires from the wires attached
to the ignitor module. Leave the electrode attached to the oven
fi rewall.
5. To remove the heat shield, fi rst cut the zip ties. Then lift the heat
shield up and inward slightly to clear the diagonal slots hooked over
the oven fi re wall then pull away from the manifold (see Fig. 4-1).
6. Install the infrared burner by fi rst sliding it over the orifi ce, then
line up the two tabs in back of the burner with the two slots in the
back of the grill and lower them carefully into place (see Fig. 4-2).
Fig. 4-1 Remove heat shield
(Old electrode)
Fig. 4-2 Install new burner
Lift heat shield up and
away from manifold
Remove zip ties
INSTALLATION (cont.)