Fire Magic 3593 New Ice Maker - Manual (Page 4)

REV 1 - 1401311400 L-C2-393 4
• Use two or more people to move and install ice maker. Failure to do so can result in back or other
injury.
• To ensure proper ventilation for your ice maker, the front of the unit must be completely unobstructed.
Choose a well-ventilated area with temperatures above 45˚F (7˚C) and below 110˚F (43˚C).
• The ice maker is designed to be installed in an outdoor kitchen, but must not be placed directly
adjacent to a grill or other source of high heat. A minimum clearance of 6" from all sources of high
heat must be maintained at all times.
• The ice maker must be installed with all electrical and water connections in accordance with state
and local codes. A standard electrical supply (115VAC, 60Hz, 15A), properly grounded in accordance
with the National Electrical Code and local codes and ordinances is required.
• Do not kink or pinch the power supply cord between the ice maker and cabinet.
• The fuse (or circuit breaker) size must be 15 amperes or higher.
• It is important for the ice maker to be leveled in order to work properly. You may need to make
several adjustments to level it.
• All installations must be in accordance with local plumbing code requirements.
• Make certain that the hoses are not pinched or kinked or damaged during installation.
• Check for leaks after connection.
• Although the unit has been tested at the factory, due to long-term transit and storage, the fi rst batch
of cubes must be discarded.
• Remove the packing materials and clean the ice maker before using.
• Turn on the water supply tap before switching on the ice maker. Never turn the water supply tap
off when the ice maker is working.
• Except to take ice from the unit, keep the door closed in order to reduce ice melting and to promote
proper ice formation.
• If the ice maker will not be used for a long time, before the next use it must be thoroughly cleaned.
Follow carefully any instructions provided for cleaning or use of sanitizing solution. Do not leave
any solution inside the ice maker after cleaning.
• DO NOT touch the condenser fi ns. The condenser fi ns are sharp and can be easily damaged.
• DO NOT use solvent-based cleaning agents or abrasives on the interior. These cleaners may
transmit taste to the ice cubes, or damage or discolor the interior.
• The ice machine cleaner contains acids. DO NOT use or mix with any other solvent-based cleaner
products. Use rubber gloves to protect hand. Carefully read the material safety instructions on the
container of the ice machine cleaner.
• Do not use this apparatus for other than its intended purpose.
WARNING
IMPORTANT SAFEGUARDS (cont.)