Fire Magic Aurora Stand Alone Combo Grill A830s - Manual (Page 12)

12
CRANK INSTALLATION
Fit the crank handle into the
hole on the front right side of the
face. Aligning it carefully, screw
it into the nut on the frame. After
installation, crank the handle in
and out to raise and lower the
charcoal pan.
INSTALL THE TOOL HOLDER AND
PAPERTOWEL HOLDER
The rectangular mounting bracket for the tool
holder and the paper towel holder come pre-
attached to the sides of the cart.
Unpack the holder portion, squeeze the open
ends together slightly, and install them into the
mounting bracket (see Fig. 12-2). Next, release
the hanger so that the ends extend out through
the holes in the top and bottom of the mounting
bracket (Fig. 12-3, 12-4).
When not in use, the racks may be folded back
against the wall of the grill (Fig. 12-3, 12-4).
LOCATION PREPARATION
Prepare a fl at, level surface capable of supporting
the weight of the stand-alone grill and convenient to
the gas supply if connecting to a gas line.
WHEELS AND CASTERS
To lock a caster press down on the side of the lever
with the word "ON" stamped on it until it stops and
the caster will not turn. To unlock, press down on the
side stamped "OFF."
INSTALLING THE STAND-ALONE UNIT
Fig. 12-1
Fig. 12-2
Fig. 12-4
Fig. 12-3
CONNECT THE GAS SUPPLY
For connecting a propane unit to a portable
propane tank, read the safety warnings and follow
the instructions in the section SAFE USE AND
MAINTENANCE OF PROPANE GAS CYLINDERS.
For household propane or natural gas units:
1. Turn OFF the gas supply at the source. The
quick disconnect hose is pre-installed on the
valve manifold at the manufacturer. Run the
hose through the hole in the bottom rear of the
stand-alone unit, to the gas supply. Connect
the
1 /
2
" NPT socket at the end of the hose to
the gas supply. Use pipe joint compound that is
resistant to all gasses on the male pipe fi tting
and tighten securely. DO NOT use pipe joint
compound to connect the fl are fi ttings.
2. Turn all burner valves to the OFF position. Turn
the gas supply on. Then carefully check all gas
connections for leaks with a brush and soapy
water before lighting. NEVER USE A MATCH
OR OPEN FLAME TO TEST FOR LEAKS.
Fig. 12-5
REV 0 - 1412031405 L-C2-453