Fire Magic Echelon Insulating Liner - Manual (Page 3)

3
Refer to the grill safety precautions and installation
instructions to install the grill.
For Echelon E1060i units with the powerhood op-
tion shift the grill to the left in the liner as required
by the powerhood motor and gearbox on the right.
DO NOT ALLOW THE GRILL HANGER TO COME
IN CONTACT WITH THE COUNTERTOP OR ANY
COMBUSTIBLE SURFACE (Fig. 3-2).
Replacement parts may be obtained from your nearest
Robert H. Peterson Co.
dealer. For assistance in
locating a dealer, you may contact the factory at the
address listed below.
INSTALLATION (cont.)
Fig. 3-2 Slide-In grill with hanger
Grill hanger - rests
on insulating liner
(sides & rear)
Fig. 3-1
Outside panel wall
Countertop & top of
insulating liner are at
the same level
Insulating liner
Inside
panel
wall
Silicone bead
Liner installed
orientation
REV 8 - 1302051115 L-C2-240