Fire Magic Echelon Insulating Liner - Manual (Page 2)

2
IMPORTANT INFORMATION & TECHNICAL DATA (cont.)
Y
Penciled
lines
X
Front
Support
hanger (2)
Fig. 2-1 Interior Side View
Countertop
Stud
A
Support hangers are to sit level
with the top of stud A
Note: Additional framing may be necessary to
properly anchor the support hangers.
1. On the inside of the grill opening, pencil in a vertical
line X" from the front of the enclosure. Then, pencil
in a second line, Y" (back) from the fi rst line. (See
Table 1 and Fig. 2-1 for dimensions). Do the
same on the opposite side as well.
Note: The distance between lines 1 and 2 must be Y"
to allow for proper alignment and installation
of the heat shield with the support hangers
(see Fig. 2-1 & Fig. 2-2).
2. Align the top of the support hangers level and fl ush
with the opening 12" down from the countertop
(i.e., the top of stud A). Line up hanger holes with
your penciled lines (see Fig. 2-1 & Fig. 2-2) and
screw into position.
3. Bend the 4 heatshield tabs upward, slightly less
than a right angle, approximately 85°. Insert the
tabs into the slots located at the bottom of the two
support hangers. Once inserted they will slightly
flex outward and lock in position. (See Fig. 2-3.)
4. Install the insulating liner as shown in Fig. 3-1. Top
of liner must be fl ush with countertop.
INSTALLATION
Note: Drawings not to scale. Reference Table 1
and Table 3 for dimensions.
Fig. 2-2
Installation
Fig. 2-3 Front view
85°
Support hanger
Heatshield
85°
Countertop 12"
Front view
37"
Height
(Nominal
frame height)
Support hangers
(must sit level, and fl ush
with the top of stud A)
Width
Heat shield
Note: D i s t a n c e f r o m t o p o f
counter top to top of the
support hangers/Stud A must
be 12". Distance from Stud A
to any combustible material
below must be 5" (to allow for
heat shield clearance).
5"
Stud A
Stud A
Combustible
material
Depth
X
Y
REV 8 - 1302051115 L-C2-240
12"
Table 3 - Hanger setback dimensions
Model Front (X) † Rear (Y) †
E660i 6
1
/
4
" 12
1
/
4
"
E790i 6
1
/
4
" 12
1
/
4
"
E1060i 6
1
/
4
" 12
1
/
4
"
† See Fig. 2-1 for hanger setback detail