Daewoo DWD-E1211R'S User Manual

Page 16

5. HEAVY STRAIN PROGRAM

Note

• If you want to change the setting program during operation, press the 'Start/Pause' button to hold the

operation and change the program you want to change by pressing each corresponding button.

• Water temperature '95°C' is not selected in order to prevent clothes from damaging.
• If you want to add the clothes during operation, press 'Start/Pause' button and 'Door unlock' button, then

open the Door and put the clothes into the Drum and then close Door and press 'Start/Pause' button again.

Put the laundry into the Drum and put the detergent and softerner into the detergent
case.
Then close the Door.
• Put the detergent into the main wash room(I I marking) and prewash room(I marking)

in the detergent case.

• Softener should be below 'MAX' level.
• Put the detergent into the pre wash room(I marking) only if you want to add prewash.
• When you want to use bleach, put it into the main wash room (I I marking) with

detergent.

Press the Power button.
• The LED shows only '- --' signal.

Select the 'HEAVY STRAIN' program using the program selection dial.
• If you press 'Start/Pause' button aftrer pressing Power button without selecting

program, the 'NORMAL' program is selected as default program.

• 'Pre wash' and '3' times rinse and '800' rpm spin speed and '40°C' water temperature

are selected automatically.

• If you want to change the 'Washing course' and 'Rinse time(s)' and 'Spin speed' and

'water temperature', select program what you want to change by pressing each
button.

Press the 'Start/Pause' button.
• The washer will be operated with locking Door and supplying water.