FiberPlex WDM8 User Manual
Page 15

Removing a Module
1) Attach an ESD‐preventative wrist or ankle strap, following its instructions for use.
2) Disconnect and remove all interface cables from SFP Module.
3) Release the latching mechanism.
Bail Clasp – Open the bail clasp on the SFP Module with your finger in a downward direction.
Actuator Button – Gently press the actuator up (or in) while pulling the body of the SFP Module to release the SFP
Module from the cage.
Actuator Button
Mylar Tab – Pull the tab gently in a straight outward motion until it disengages from the
port. Make sure the tab is not twisted when pulling as it may become disconnected from
the SFP Module.
Slide Tab ‐ With your thumb, push the slide tab on the bottom front of the SFP module in
the direction of the equipment to disengage the module from the line card port. If you
pull on the SFP module without disengaging the tab, you can damage the SFP module.
4) Grasp the SFP Module between your thumb and index finger and carefully remove it from the port
5) Place the SFP Module on an antistatic mat, or immediately place it in a static shielding bag or container