Fenix Watts V27 - Manual (Page 29)

29
Example 2: Z1 (Regulation Zone)
Then the module should answer you with a SMS like this:
Once this message received you will have the possibility to send back it with a different setting point
temperature or working mode by return the text of the SMS received and forward it with the only changes
marked in green on the example below.
Example of modification
You should receive a confirmation SMS with your last change few minutes after.
Z1= Living
Status = Ok
Room = 21.4C
SetPoint = 21.0C
Mode = AUTO
Heating = 1
Status of the zone,
Ok => to say that the zone work properly.
Error => to say that the zone is faulty (thermostat batteries, receiver problem
…)
Actual room temperature in °C.
Name of the zone “Living”, the name displayed is the name chosen on your V24
Central unit. (The name will be always received in GB language)
Actual setting point of the room in °C.
Note: You will have the possibility to change the setting point.
Possible change “05.0°C to 35.0°C”
Actual working mode. (Auto, Manual, Antifreeze, OFF)
Heating indication. (1 = Heating demand / 0 = No heat demand)
Z1= Living
Status = Ok
Room = 21.4C
SetPoint = 20.0C
Mode = MANUAL
Heating = 1
No possibility for change.
New setting point temperature “20.0C” for Z1.
Change possibility between 5.0 to 37.0C
No possibility for change.
No possibility for change.
New working Mode possible:
Text available V24 corresponding Symbol Setting point change possibility
MANUAL Yes
AUTO Yes (Override 2H)
ANTI-FREEZE Yes
OFF Non applicable
No possibility for change.