Fenix Watts V27 User Manual

Page 26

First start

– install a SIM-

card in

the GSM-controller and control the working

6.3

Unplug the power supply of the GSM controller

Install a SIM card, (*without PIN code) in the right side of the controller (See picture below).

* In order use a mobile phone to de-activate the PIN code.

Now if the GSM is used with wireless communication, plug the RF antenna RJ45 connector on
the GSM unit.

Plug 230V/9VDC power supply (only the plug adaptor supplied or one with the same character-
istics can be used).

Then the unit starts the initialisation (up to 1 min) and connection to the GSM network. During in-
itialisation the two first LED must blink alternatively (Green/Red), the network LED starts to blink
when connected to the network.

Your GSM Module is now ready to work and be linked with your installation, to make this put
your GSM Module in

“init” mode by pressing 5 sec on the push button, the antenna LED must

shine in green fix.

Go to your V24 Central and active the GSM pairing mode, (see the V24 leaflet for more infor-
mation)

Once the pairing made between V24 Central and V27 GSM unit, you can check the SMS func-
tionality.

If the GSM controller is supplied with an internal battery, a preliminary time charge for 24H will be need-

ed to have the power supply supervising function SMS alert.