Installation, Electric installation, Panel control – Fenix PANEL MR User Manual
Page 11

11
Installation
The panel is supplied separately in a cardbox and fixed to a wall with mounting
brackets
.
The panel can be installed on the wall lengthwise or widthwise; mount-
ing the panel on the ceiling is forbidden (fig. 4). Drill the holes for the mounting 
brackets according to fig. 5 (lengthwise panel installation) or fig. 6 (widthwise 
installation).
Dimensions A are distances between the drilled holes and dimensions B, C and D 
are minimum distances of the holes from surrounding objects. 
Fasten the brackets with screws into dowels (not included). The dowels should be 
selected in respect of a wall material type and higher weight of panel. Hang the 
panel on the mounting brackets with two upper screws (according to suspension) 
and fasten firmly to the brackets with nuts with washer. For horizontal suspensi-
on, nuts are screwed on two screws of the panel. 
Besides the mounting brackets, the panel includes adjustment rests fastened to 
the lower screws of the panel and adjusting the distance between the panel and 
the wall and the mounting bracket cover. Fig. 3 shows a side view of the panel 
suspended on the wall.
Electric Installation
The panel is equipped with a two-core cable. 
Power supply — 1/N 230 V / 50 Hz 
Colour indication of wires: 
 Phase 
—
brown
,
Central (working) conductor —
blue
.
The cable can be fitted with a plug (export markets), removal of the plug 
and shortening of the supply lead will not result in loss of warranty
.
The power supply cable is connected to the wall junction box, see Fig. 3. If power 
supply cable is damaged, then it may only be replaced by manufacturer or its 
service technician or similarly 
qualified person in order to prevent dangerous situation. 
 
 
Panel Control
The panel control by external room thermostat equipped with a switch is recom-
mended. 
The room thermostat maintains set air temperature in a room. 
Moreover, the panel is equipped with a limiting thermostat which regulates the 
panel surface temperature not to exceed 110 °C.
fig. 4
fig. 5
fig. 6
