Fenix ADSV - Manual (Page 9)

9
ROCEDURE:

Clean the base area, remove any sharp objects and penetrate it using a suitable penetrating solution.
 Create “pockets” in the base material where you will place connections for the heating components.

Lay and affix the cable onto the surface so that it cannot move when you apply the sealing cement.

Measure the heating circuit resistance and the insulation resistance or the leakage current resistance
and record the values in the certificate of warranty.

Draw the scheme of the heating cable layout in the certificate of warranty.

Use flexible adhesive sealing cement and a notched spreader to smooth the floor surface (be careful
not to damage the cable by the sharp edge of the notched spreader).

Before laying the floor tiles, measure the heating circuit again and record both values in the certificate
of warranty.

Lay the floor tiles on the surface.
SECTIONAL VIEW OF THE FLOOR FOR PLACING CABLE INTO ADHESIVE SEALING CEMENT
Direct heating system — new constructions
Direct heating system — reconstruction
1) Floor tiles
2) Flexible adhesive sealing cement
3) Installation pipe with a floor probe
4) ECOFLOOR heating cable
5) Spread layer
6) Reinforcing steel grid (KARI)
7) Thermal insulation 80–100 mm
8) Base
1) New floor tiles
2) Installation pipe with a floor probe
3) Flexible adhesive sealing cement
4) ECOFLOOR heating cable
5) Thermal insulation F-BOARD
(optional)
6) Flexible adhesive sealing cement
7) Original floor tiles or another base