Denon D-AJ03 - Manual (Page 6)

6
ENGLISH
2 CONNECTIONS
• Do not plug in the power plug into an outlet until all connections
have been completed.
• Insert the power plug securely. An incomplete connection will
cause noise to occur.
NOTES:
• Do not bundle the (pin plug) connection cables together or place
them close to other electrical products such as TVs since this may
cause hum or other noise.
(1) Connecting Antennas and Audio Equipment
1. Pull out 2. Bend 3. Insert into hole 1. Lower the lever 2. Insert wire 3. Release
Rear Panel Names and Connections
Connection of Audio Equipment
q
FM antenna terminal
w
MONO output terminal
e
AUX input terminal
r
AM loop antenna terminals
• These connect the supplied AM loop antenna.
MONO
OUT
AM
LOOP ANT.
FM
AUX IN
ANTENNA
w q e r
50 MIN
To listen to equipment that is connected to the external input
terminals, set the input to “AUX” with the remote control
external input selection button.
Assembly of the AM loop antenna Connection of the AM loop antenna
Super woofer
FM antenna
Power cord
Use a connection cable
that is available on the
market.
Portable player, etc.
AM loop antenna
Note to CATV system installer:
This reminder is provided to call the CATV system installer’s
attention to Article 820-40 of the NEC which provides guidelines
for proper grounding and, in particular, specifies that the cable
ground shall be connected to the grounding system of the
building, as close to the point of cable entry as practical.