EXCALIBUR RD70-OA SoundMaster Classic 5-in-1 Music Center - Manual (Page 7)

Specifications
AMPLIFIER section
Output Power: 2.0 W + 2.0 W
Frequency Response: 60 TO 20, 000 Hz
TUNER section
FM Section Frequency Range:
88 to 108 MHz
AM Section Frequency Range
530 to 1710 KHz
CD PLAYER section
Frequency Response
60 to 20, 000 Hz +/-4 Db
Signal-to-Noise Ratio 55 dB (IEC-A)
RECORD PLAYER section
Motor DC servo motor
Drive System Belt Drive
Speeds 33-1/3 rpm, 45 rpm and 78 rpm
Flutter Less than 0.25% (WTD)
S/N Ratio More than 50 dB
Cartridge Type Ceramic Stereo
Cartridge Stylus 402-M208-165
Output Level 160-380 mV
(5 cm/sec at 1 KHz)
SPEAKER SYSTEM section
Type 1-way
Impedance 8 ohms Input
Power Max.
5
GENERAL
Power Requirements AC 120 V~ 60 Hz
Power Consumption 19 W
Dimensions 18ʼʼ x 13.2ʼʼx 9.6ʼʼ
(approx.)
Weight 18 Ibs. (approx.)
Users Guide
45 RPM Adapter
12 13
8. To replace or remove a
CD, press the OPEN / CLOSE but-
ton and carefully lift the CD out.
Carefully hold the CD by the
edge to avoid fingerprints.
Precautions:
If the CD is scratched, dirty,
or in-correctly placed on the
disc tray, it may not play prop-
erly.
Bear in mind the following
points since any dirt; scratches
or warping of the disc can cause
broken or intermittent sound
and noise.
When holding the discs, take
care not to touch the playing
surface.
Do NOT place discs near a
heating device or place where
the temperature is high OR in
damp or dusty areas.
Wipe away any fingerprints
or dust on the playing surface
of the disc using a soft cloth.
Always wipe from the inside
toward the outside of the disc.
Return your CD to its case
after use to avoid serious
scratches that could cause the
laser pick up to skip.
Do NOT expose any CDs to
direct sunlight or high humidity
and temperature for any extend-
ed periods.
Do NOT stick paper or write
anything with a ballpoint pen on
the surface of the label side.
Do NOT use irregular shaped
CDʼs (octagonal, heart-shape,
etc.), all of which can damage
the unit.
Do NOT switch the unit off
while playing a CD – this will
damage the unit.
To play a cassette
tape:
1. Load the cassette tape into
the slot. Playback will begin
immediately.
2. Press the button halfway in
to fast forward the tape. Press
the button lightly to resume nor-
mal play.
3. Press the button all the way
in to eject the tape.
To play from an MP3,
iPod
® or computer:
1. Insert the connecting line
from the output of an external
source, such as an MP3 player,
iPod
® or computer, into the AUX
IN jack on the back of the unit.
2. The unit will receive the
signal and sound will play.
3. Only volume control can be
operated during this function.
4. Remove the AUX IN cable to
resume normal function.