Exacq exacqVision Edge/Vivotek Quick Start Guide User Manual
Page 2
www.e
x
acq.com
Page 2 of 5
10/17/2014
Installation and Configuration
CAUTION: Do not record from an IP camera on more than one exacqVision server at a time, regardless of where exacqVision Server
is running.
1. Install the Vivotek camera and insert the SD memory card in the camera.
NOTE: SD cards are normally pre-formatted to the FAT32 file system and automatically mounted when inserted. However,
you can re-format the card using the camera, if desired, by following the instructions provided by Vivotek.
2. Configure the camera’s network parameters to communicate with a PC-based browser using the Vivotek Setup Wizard
found on the CD shipped with the camera, or downloaded from the Vivotek website.
3. If necessary, upgrade the camera firmware to the latest version from the Vivotek website.
4. Download the latest exacqVision Client application from the Exacq website a
5. Install the client software on your computer.
6. Download the latest exacqVision Edge server application from
7. Open a browser to the camera and log in. The default username and password are root and pass.
8. Select Advanced Mode. If you do not see Advanced Mode, but you do see Basic Mode, you are already in Advanced Mode.
9. Under Local Storage, select SD Card Maintenance.
10. Ensure the Total Size is greater than zero, which means the camera is communicating with the SD card.