Exacq exacqVision Edge/IQeye Quick Start Guide User Manual
Page 5
www.e
x
acq.com
Page 5 of 5
10/17/2014
12. Add the exacqVision camera license to the camera’s server on the System Setup page. When complete, the status is
displayed as Licensed.
13. On the IP Cameras page, configure the Edge server’s connection to the camera:
The IP address must be 127.0.0.1 so that the Edge server communicates with the local camera.
The camera’s credentials are root and system by default.
The status is displayed as Connected when complete.
14. See the exacqVision user manual for additional configuration steps, such as configuring recording settings.
Troubleshooting
If you encounter a write error, complete the following steps:
1. Check the SD card. If necessary, repair and format the card by clicking Format on the DTS tab of the camera’s web page (as
shown at the bottom of the illustration in step 9 of the previous procedure). CAUTION: This will delete any data stored on
the SD card.
2. Remount the SD card and restart exacqVision Edge server by clicking Reboot Camera on the Network or Security tab of the
camera’s web page (as shown at the bottom of the illustration in step 10 of the previous procedure).