ETA Svářečka fólií Electronic - Manual (Page 17)

IV. TROUBLESHOOTING
Malfunction Cause Solution
weld on the
foil is not tight
insufficient pressure the lid must be pressed strongly with
both hands
creases in the seal smooth out the foil then repeat
welding
welds follow too fast after each
other
keep the 30 second break between
individual welds
food leftovers or moisture in the
weld
remove the food leftovers and dry
the foil
not keeping the time necessary
for processing the weld
wait until the control light turns off
pressing only one side of the lid press the lid tight with both hands
the welder
does not
suck air
the bag is not in the sucking
nozzle (area)
place the bag correctly
the bag is stuck together before
the nozzle
lift the bag slightly and stretch
the sucking nozzle of the
exhauster is clogged
clean the nozzle
Storing the supply cord (A4)
Store the supply cord in the compartment in the back part of the appliance (pic. 1).
V. MAINTENANCE
Disconnect the appliance from the el. outlet by pulling out the fork of the supply cord from
the socket before each maintenance. Wipe the outer surface with a soft damp cloth after
each use. Do not use any rough and abbrasive cleaning agents! Never dry the plastic
die-cast over a heat source (e.g. stove, el./gas cooker). Remove residues of the foil from
the welding wire by making one weld without using foil. Store the appliance thoroughly
clean on a dry, dustless place out of reach of children and persons sui juris.
VI. ENVIRONMENTAL PROTECTION
If the dimensions allow, there are labels of materials used for production of packing,
components and accessories as well as their recycling on all parts. The symbols specified
on the product or in the accompanying documentation mean that the used electric or
electronic products must not be disposed of together with municipal waste. For proper
disposal of the product, hand it over at special collection places where it will be taken
over free of charge. Suitable disposal of the product can help to maintain valuable natural
resources and to prevent possible negative impacts on the environment and human
health, which could be the possible consequences of improper waste disposal. Ask for
more details at the local authorities or in the nearest collection site. Fines can be imposed
for improper disposal of this type of waste in agreement with the national regulations.
If the appliance is to be put out of operation for good, after disconnecting it from power
supply we recommend cutting off the power cord and thus it will not be possible to use the
appliance again.
17
GB
/ 28