ETA Svářečka fólií Electronic - Manual (Page 16)

II. FEATURES (pic. 1)
A – case of the welder
A1 – indicator light A3 – air exhauster nozzle
A2 – welding wire A4 – power cord
B – foldable lid
C – PE foil roll
III. INSTRUCTIONS FOR USE
Remove all packaging, take out the appliance and connect the fork of the supply chord
to a socket. The welder is supplied with a roll of PE foil. When welding the first bag, it is
necessary to follow the following process:
– Fold back the B lid and unwind a sufficient amount of the foil C so that it exceeds the
welder by 2 to 4 cm. Check if the welded spot is dry and clean, fold the lid B back
afterward. Make sure the foil is stretched straight without any creases on the welding
wire A2 before welding.
– Press on the lid B with both hands in order to make a perfect weld (pic. 2) and wait for
the indicator light A1 to turn off (approx. 10 sec). The indicator light signals the PE foil is
being welded.
– Remove the rest of the foil by tearing before folding back the lid B.
Air suction and bag welding
Fill the prepared bag to ¾ max. of its length (capacity) with food or anything you want to
keep fresh. Place the open end of the bag on the welding wire A2 so that the air suction
nozzle A3 is inside the bag‘s opening. Check for creases or folds in place of the future
weld. The straighter this area is, the better. Fold the lid B on and push lightly on the right
corner of the lid, which will trigger the air suction (you will hear the motor), hold the lid in
this position but do not push it all the way down.
Place both hands on the lid and press hard after the suction of air from the bag is
completed (pic. 2).
The weld is done after the indicator light A1 turns off.
Operating times
suction welding pause
30 sec. 10 sec. 80 sec.
Welding without suction
Place the open end of the bag on the welding wire A2 and make sure there are no folds or
creases in place of the weld. Press on the lid B with both hands in order to make a perfect
weld (pic. 2).
Attention:
Do not use the welder longer than 15 minutes at a time. Turn it off for 30 min. afterwards to
let the appliance cool off. The firmness of the weld depends on the pressure exerted on the
lid B. Strong pressure = good weld. Weak pressure = bad weld. After some practice you
will be able choose the right pressure to achieve a good quality weld.
16
GB
/ 28