ETA Anna - Manual (Page 18)

III. INSTRUCTIONS FOR USE
Remove all the packing material and take out the electric kettle with the stand. Remove all
possible adhesion foils, stick-on labels or paper from the appliance. Before the first use, fill
the electric kettle with clean water to the maximum level, turn it on and let the water boil.
Then pour out the water and repeat the procedure several times (at least five times).
Unwind the necessary length of the power cord B2 from the storage space of the stand
B. Place the stand on a suitable surface and plug the fork of the power cord to the electric
socket (kettle beeps 2x). Hold the kettle A on the handle A2. Open the lid A3 by pressing the
lock button A4. Fill the kettle with drinking water. The maximum amount of water is marked
on the water gauge A1. Close the lid by snapping. Put the electric kettle on the stand.
Turn on the kettle by pressing the button (the red indicator light will turn on). Press the
respective button B5 according to the required water temperature. When water reaches the
set temperature, heating stops and the appliance is switched off „automatically“ (a sound
signal will be heard = 2x beep, the indicator light will shine continuously for about 1 minute).
Before reaching the set water temperature, the appliance can be switched off „manually“ by
repeated pressing the respective button B3 (the control light will go out). Always use fresh
drinking water for boiling.
Temperature maintenance feature
If you wish to heat water to desired temperature while maintaining the temperature, press the
button for desired temperature (you may do so before as well as after choosing the desired
temperature). The back light of the button turns on and the back light of the chosen
temperature flashes. Upon reaching the desired temperature, the kettle beeps 2x and the
back light of the B1 switch, the maintenance button B4 and the set temperature B5 remains
on. The kettle maintains the set temperature for 30 minutes, then beeps and turns off (the
backlight turns off). When pressing the temperature maintenance button, the kettle keeps
maintaining the set temperature.
Note
– The control on the stand does not work without the kettle on it.
– If the water in the kettle is warmer than the temperature set for maintaining, the
backlight of the temperature maintenance button is on and the chosen temperature
button flashes. Upon cooling down to the desired temperature, the kettle beeps 2x and
the backlight of the B3 switch, the maintenance button B4 and the set temperature B5
remains on. The kettle keeps the set temperature.
– If you wish to change your settings after selecting the desired temperature, the kettle
must be turned off and the process of setting repeated from the beginning. Proceed
this way in case you heated the water e.g. to 100 °C, but you wish the kettle to inform
you when the temperature drops to lower temperature (e.g. 70 °C).
– Lifting the kettle off the stand cancels all the set functions.
i
Water temperature setting
With switches B5, you can set the required temperature of water heating. The temperature
and time heating depends on the amount of water and the initial temperature of water.
For the correct temperature setting, follow the manufacturers‘ instructions that are described
on food packages (e.g. tea, coffee, instant drinks, soaps, etc.).
18
GB
/ 34