ETA Fresco - Manual (Page 17)

– Always use the mixer with the stand only in the operating position and in places where
there is no risk of it tipping over. Never use the appliance near sources of heat (such as
the stove, electric or gas ring, etc.) or wet surfaces (such as wash basins, kitchen
sinks, etc.).
– Do not switch on the appliance without substances put in!
– Use the appliance designed for this type only. Using another appliance can represent
a risk for the operator.
– While the motor unit is running, never attempt to remove the tools (such as the beaters,
hooks or blender), the bowl and lid and never tilt the mixer arm!
– Take care that the cord never got in the way of the rotating tools.
– On safety grounds, it is not possible to change the tools while the motor unit is running.
– Each time before plugging the appliance in the mains check whether the appliance
master switch is in the OFF position ‘0’ and after finishing your work always unplug the
appliance off the mains.
– Be careful when pouring hot liquid into the food processing device or the mixer because
it may spurt out of the appliance because of sudden boil.
– Do not process food at temperature exceeding about 80 °C.
– Never insert e.g. fingers, fork, knife, spatula or spoon into the rotating parts of the
appliance and the accessories.
– Once the processed food starts sticking to the tools (such as the beaters, kneading
hooks or the blender blade, the lid or the bowl, switch the appliance OFF and clean
the tools carefully with the spatula.
– While handling the mixer, take care that the tools never beat against the bowl walls or got
stuck in sticking substance or frozen food.
– Check the condition of the power cord of the appliance regularly.
– Make sure that the power cord does not hang over the edge of the working table where
children could reach it.
– If you need to use the extension cord, it has to be uncorrupted and it has to comply with
the valid standards.
– The cord must never be damaged with any sharp or hot object, by contact with flame or
water.
– Never use the appliance for other than its designed purpose as outlined in this instruction
for use!
– The producer does not undertake any responsibility for damage caused by improper use
of the appliance and the accessories (e.g. food deterioration, injury by knife edge,
fire, etc.) and its guarantee does not cover the appliance in the case of failure to comply
with the safety warnings above.
II. DESCRIPTION OF THE APPLIANCE AND THE ACCESSORIES (Fig. 1)
The basic model 0047 includes the motor unit, the beaters and kneading hooks. The model
1047 includes the motor unit, the beaters, kneading hooks, dip blender and accessory
holder. Model 2047 includes in addition the stand with rotary bowl, bowl lid and spatula.
204790011 version does not have dip blender.
A – motor unit
A1 – ON/OFF and speed switch A4 – drive holes to connect the tools ( E, F)
A2 – MAX button A5 – lifting blend drive cover
A3 – ejector button A6 – power cord
17
GB