ETA Sting - Manual (Page 22)

Storing the accessories and the vacuum cleaner
Slide the upholstery nozzle to the cavity in the adapter (Fig. 16). The vacuum cleaner can
be hung on a clip using the cavity in the handle (Fig. 18) or place the vacuum cleaner to
vertical position in which the floor nozzle is locked (Fig. 19), (you will hear an audible click).
Do not put the assembled rod vacuum cleaner on an uneven surface! The cleaner must be
placed on a flat surface where there is no danger of knocking over.
IV. MAINTENANCE
Always store the vacuum cleaner at a dry place, far enough from heat sources (e.g.
fireplace, stove, heating element) and protect it against weather conditions (e.g. rain,
sunshine). Treat surface of the appliance with a soft and damp cloth, do not use coarse
and aggressive detergents! When storing, always set the floor nozzle to the carpet
position (i.e. with the brush retracted), thus you will prevent bending of the bristles. Store
the appliance properly cleaned at a dry, dust-free place out of reach of children and
incapacitated people. Do not put the assembled rod vacuum cleaner on an uneven surface!
The cleaner must be placed on a flat surface where there is no danger of knocking over.
Floor nozzle / floor nozzle with rotation brush
After any vacuuming it is recommended to check visually the brushes or collectors for
possible impurities. If you find some impurities, remove them in the way specified below.
Cut threads and hair with scissors and remove them. If hair or threads are twisted around
the mounting of the drive shaft and if they cannot be removed in the way described
above, the impurities have to be removed by dismantling the nozzles.
v. TROUBLESHOOTING
Problem Cause Solution
Motor won‘t start Power supply not connected Check the cord, plug and
the socket
The „ O“ button is not in the „min“
position
Turn the switch to „ min“
position or to „ max“ position
The lid cannot be
closed
Dust filter inserted in the suction
space improperly
Check/correct the position of
the carton front of the filter
ATTENTION
– Maximum suction effect will always be reached with a clean dust filter and
microfilters.
– Micro–filters are not designed for washing.
– Failure to replace the filters may lead to damage of the vacuum cleaner!
– The safety lock does not allow closing the lid of the vacuum cleaner if you forget
to insert a new dust filter.
– Make sure that the contact surfaces and sealing elements are functional.
– You can buy a replacement dust filter and a micro-filter in the elektro shop chain.
!
GB
22 / 36