ETA Sting - Manual (Page 19)

– Never use the vacuum cleaner with wet hands or feet!
– Do not let the appliance in operation without supervision!
– Never immerse the vacuum cleaner into water (even its parts)!
– When carrying, do not hold the vacuum cleaner on the power supply. Always use the
handle of the vacuum cleaner.
– Before you start using the vacuum cleaner, please check that all the locking mechanisms
are in the right position.
– Do not vacuum wet or damp floor coverings! When moisture gets into the aggregate, there
is a risk of its damage and disabling it. This defect is not covered by the warranty.
– When vacuuming some kinds of carpets, electrostatic discharge may occur which is not
dangerous for the user.
– Do not vacuum sharp objects (e.g. glass, shatter), hot, flammable, explosive items (e.g.
ash, hot cigarette butts, gasoline, thinners and aerosol vapours) or greases (e.g. fats,
oils), caustic agents (e.g. acids, solvents). Vacuuming these objects may lead to damage
of the dust filters or the vacuum cleaner.
– Do not put fingers or other things to input and output vents of the appliance. If the vents/
elements for air flow are clogged (e.g. nozzle), turn the appliance off and remove the
clogging completely.
– Pores of the dust filter may be clogged when vacuum cleaning very fine dust. Thus, air
permeability will be reduced and the suction performance will decrease. In this case the
dust filter must be changed and clean micro–filters, even if the dust filter is not full yet.
Do not use the vacuum cleaner to vacuum dirt produced during/after construction such as
plasterboard dust, fine sand, cement, dust from construction, parts of plaster etc. If
this dirt / loose construction materials / loose construction materials into the aggregate, it
poses a danger of damage. The warranty repair does not cover this.
– Never leave the vacuum cleaner exposed to weather conditions ( rain, frost, direct sun
radiation, etc.).
– If you are using the type equipped with the built–in socket for supply of the rotating brush,
it has to be unplugged from the power supply before its cleaning and maintenance.
– When taking the plug from the electric socket, never pull the power cord or the vacuum cleaner.
– Do not run over the power supply cord when using the vacuum cleaner and do not unplug
it from the socket by pulling the power cord.
– The power cord must not be damaged with sharp or hot objects, open fire, it must not be
sunk into water or bent over sharp edges.
– Check the condition of the power cord of the appliance regularly.
– If you need to use an extension cord, it has to be uncorrupted and it has to comply with
the valid standards.
– Never use the appliance for any other purpose than for the intended purpose described
in these instructions for use!
– In order to ensure safety of the appliance, use only original spare parts and accessories
approved by the manufacturer.
– The manufacturer is not responsible for damage caused by improper use of the appliance
and the accessories and its guarantee for the appliance does not apply in situations
when the safety warnings above are not complied with. Failure to replace or maintain all
filters regularly according to the instructions in Chapter IV., V. and also using non-original
filters, the properties of which resulted in failure or damage of the vacuum cleaner, is also
understood to be improper use of the appliance.
– All text in other languages and pictures shown on the packaging, or the product itself, are
translated and explained at the end of this language mutation.
GB
19 / 36